A Spatial and temporal variation of PM₂.₅, TVOC, formaldehyde and combustion gases around a tile manufacturing facility in Kachi Town, Dutse, Jigawa State, Nigeria
Keywords:
ambient air quality; PM₂.₅; tile manufacturing; spatial and temporal variation; Jigawa StateAbstract
Industrial facilities that process minerals can raise ambient concentrations of particles and gases in nearby communities, but local evidence on how far the effect extends and when it peaks is scarce in northern Nigeria. Fine particulate matter (PM₂.₅), formaldehyde (HCHO), total volatile organic compounds (TVOC), carbon monoxide (CO), carbon dioxide (CO₂), temperature and relative humidity were measured with one portable multi-parameter monitor at five locations (the fenceline, receptors at 100 m, 500 m and 1 km, and a comparison location at 2 km) in the morning, afternoon and evening of three consecutive days (45 readings). Because the same nine sessions were sampled at every location, spatial differences were assessed with the blocked Friedman test and Wilcoxon signed-rank comparisons with the 2 km location (Holm-adjusted), and temporal differences with the Friedman test. The results revealed a consistent decline in concentrations with increasing distance from the facility. Mean PM₂.₅ decreased from 106.11 µg/m³ at the fenceline to 34.67 µg/m³ at 2 km; HCHO from 0.063 to 0.033 mg/m³; TVOC from 0.182 to 0.061 mg/m³; CO from 3.11 to 1.00 ppm; and CO₂ from 529 to 435 ppm. This indicates a clear spatial attenuation of the measured concentrations with increasing distance from the facility. All five parameters differed among locations (Friedman p < 0.001; W = 0.87–1.00). In Holm-adjusted pairwise comparisons with the 2 km location, all five were higher at the fenceline (0 m) and 100 m (adjusted p = 0.016), all except CO at 500 m, and at 1 km PM₂.₅ and TVOC (p = 0.016) and, marginally, HCHO (p = 0.039) remained higher; CO and CO₂ did not differ from the comparison location (p = 0.50 and 0.19). Temperature and humidity did not differ among locations. All parameters varied with time of day (Friedman p ≤ 0.007) and were highest in the afternoon (mean PM₂.₅ 53.5, 77.9 and 61.8 µg/m³ in the morning, afternoon and evening), and the afternoon increase in PM₂.₅ was four times larger at the fenceline than at 2 km. Day-to-day differences were smaller. The gradient and the afternoon peak are consistent with a local source at the facility, but wind direction, production activity, traffic and other sources were not recorded, so the facility's contribution cannot be established. Wind-resolved, seasonal monitoring with calibrated instruments is needed to confirm attribution.References
Adeniran, J. A., Yusuf, R. O., Fakinle, B. S., & Sonibare, J. A. (2019). Air quality assessment and modelling of pollutants emission from a major cement plant complex in Nigeria. Atmospheric Pollution Research, 10(1), 257–266.
Awokola, B. I., Okello, G., Johnson, O., Dobson, R., Ouédraogo, A. R., Dibba, B., Ngahane, M., Ndukwu, C., Agunwa, C., Marangu, D., Lawin, H., Ogugua, I., Eze, J., Nwosu, N., Ofiaeli, O., Ubuane, P., Osman, R., Awokola, E., Erhart, A., ... Semple, S. (2022). Longitudinal ambient PM2.5 measurement at fifteen locations in eight sub-Saharan African countries using low-cost sensors. Atmosphere, 13(10), Article 1593. https://doi.org/10.3390/atmos13101593
Barkjohn, K. K., Gantt, B., & Clements, A. L. (2021). Development and application of a United States-wide correction for PM2.5 data collected with the PurpleAir sensor. Atmospheric Measurement Techniques, 14(6), 4617–4637. https://doi.org/10.5194/amt-14-4617-2021
Ferrari, G., & Zannini, P. (2017). VOCs monitoring of new materials for ceramic tiles decoration: GC–MS analysis of emissions from common vehicles and inkjet inks during firing in laboratory. Boletín de la Sociedad Española de Cerámica y Vidrio, 56, 226–236. https://doi.org/10.1016/j.bsecv.2017.04.004
Fisher, S., Bellinger, D. C., Cropper, M. L., Kumar, P., Binagwaho, A., Koudenoukpo, J. B., Park, Y., Taghian, G., & Landrigan, P. J. (2021). Air pollution and development in Africa: Impacts on health, the economy, and human capital. The Lancet Planetary Health, 5(10), e681–e688. https://doi.org/10.1016/S2542-5196(21)00201-1
Friedman, M. (1937). The use of ranks to avoid the assumption of normality implicit in the analysis of variance. Journal of the American Statistical Association, 32(200), 675–701. https://doi.org/10.1080/01621459.1937.10503522
GeoNames. (n.d.). Kachi (GeoNames ID 9410381). https://www.geonames.org/9410381
Holm, S. (1979). A simple sequentially rejective multiple test procedure. Scandinavian Journal of Statistics, 6(2), 65–70. https://www.jstor.org/stable/4615733
Idris, M., Sani, M., & Aliyu, R. (2025). Comparison of particulate matter (PM2.5) ground data and satellite data in Kano State, Nigeria. FUDMA Journal of Sciences, 9(12), 621–628.
Kendall, M. G., & Babington Smith, B. (1939). The problem of m rankings. The Annals of Mathematical Statistics, 10(3), 275–287. https://doi.org/10.1214/aoms/1177732186
Kruskal, W. H., & Wallis, W. A. (1952). Use of ranks in one-criterion variance analysis. Journal of the American Statistical Association, 47(260), 583–621. https://doi.org/10.1080/01621459.1952.10483441
Mann, H. B., & Whitney, D. R. (1947). On a test of whether one of two random variables is stochastically larger than the other. The Annals of Mathematical Statistics, 18(1), 50–60. https://doi.org/10.1214/aoms/1177730491
Minguillón, M. C., Monfort, E., Querol, X., Alastuey, A., Celades, I., & Miró, J. V. (2009). Effect of ceramic industrial particulate emission control on key components of ambient PM10. Journal of Environmental Management, 90(8), 2558–2567.
Mizutani, R. F., de Paula Santos, U., Arbex, R. F., Arbex, M. A., & Terra-Filho, M. (2023). An evaluation of the impact of air pollution on the lung functions of high school students living in a ceramic industrial park zone. International Journal of Environmental Research and Public Health, 20(21), Article 6964. https://doi.org/10.3390/ijerph20216964
Nkhama, E., Ndhlovu, M., Dvonch, J. T., Lynam, M., Mentz, G., Siziya, S., & Voyi, K. (2017). Effects of airborne particulate matter on respiratory health in a community near a cement factory in Chilanga, Zambia: Results from a panel study. International Journal of Environmental Research and Public Health, 14(11), Article 1351. https://doi.org/10.3390/ijerph14111351
Nwogu, F. U., Ubuoh, E. A., Kanu, C., Ogbaji, E. E., & Nwawuike, N. (2025). Effect of cement production processes on dry atmospheric chemistry in South-South Nigeria. Environmental Sciences Europe, 37, Article 90. https://doi.org/10.1186/s12302-025-01135-4
Pope, C. A., III, & Dockery, D. W. (2006). Health effects of fine particulate air pollution: Lines that connect. Journal of the Air & Waste Management Association, 56(6), 709–742. https://doi.org/10.1080/10473289.2006.10464485
Raub, J. A., Mathieu-Nolf, M., Hampson, N. B., & Thom, S. R. (2000). Carbon monoxide poisoning: A public health perspective. Toxicology, 145(1), 1–14. https://doi.org/10.1016/S0300-483X(99)00217-6
Salthammer, T., Mentese, S., & Marutzky, R. (2010). Formaldehyde in the indoor environment. Chemical Reviews, 110(4), 2536–2572. https://doi.org/10.1021/cr800399g
Spearman, C. (1904). The proof and measurement of association between two things. The American Journal of Psychology, 15(1), 72–101. https://doi.org/10.2307/1412159
Tafida, N. U., & Gana, S. A. (2025). Assessment of particulate matter in the ambient air of Sharada area of Kano metropolis, Nigeria. Dutse Journal of Pure and Applied Sciences, 11(3b), 202–212.
Taghizadeh, A. A., Gholami, A., & Khosravi, R. (2023). Investigating the concentration of suspended particles (PM2.5, PM10) and assessing the risk of silica dust around the tile and ceramic factory. Journal of Health, 14(1), 22–32.
Tai, A. P. K., Mickley, L. J., & Jacob, D. J. (2010). Correlations between fine particulate matter (PM2.5) and meteorological variables in the United States: Implications for the sensitivity of PM2.5 to climate change. Atmospheric Environment, 44(32), 3976–3984. https://doi.org/10.1016/j.atmosenv.2010.06.060
Tai, A. P. K., Mickley, L. J., Jacob, D. J., Leibensperger, E. M., Zhang, L., Fisher, J. A., & Pye, H. O. T. (2012). Meteorological modes of variability for fine particulate matter (PM2.5) air quality in the United States: Implications for PM2.5 sensitivity to climate change. Atmospheric Chemistry and Physics, 12(6), 3131–3145. https://doi.org/10.5194/acp-12-3131-2012
Tomczak, M., & Tomczak, E. (2014). The need to report effect size estimates revisited: An overview of some recommended measures of effect size. Trends in Sport Sciences, 21(1), 19–25.
Vicente, A. B., Sanfeliu, T., & Jordán, M. M. (2011). Comparison between industrial–urban and rural particle stations in a ceramic cluster (NE, Spain). Water, Air, & Soil Pollution, 215, 83–96.
Wilcoxon, F. (1945). Individual comparisons by ranking methods. Biometrics Bulletin, 1(6), 80–83. https://doi.org/10.2307/3001968
World Health Organization. (2010). WHO guidelines for indoor air quality: Selected pollutants. WHO Regional Office for Europe.
World Health Organization. (2021). WHO global air quality guidelines: Particulate matter (PM2.5 and PM10), ozone, nitrogen dioxide, sulfur dioxide and carbon monoxide. World Health Organization. https://www.who.int/publications/i/item/9789240034228
Downloads
Published
Issue
Section
License
Copyright (c) 2026 Jigawa Journal of Environmental and Earth Sciences (JIJEES)

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.